Steinberg UR 824 Operation Manual page 21

From the dspMixFx UR824
Click "REV-X Edit" (page 11) in the section "Master
Area."
Panel Controls
NOTE
This section uses the Hall type of REV-X as an
example.
Reverb Time
Adjusts the reverb time. This parameter links to
Room Size. The adjustable range varies
depending on the REV-X type.
REV-X type Range
Hall 0.103 sec – 31.0 sec
Room 0.152 sec – 45.3 sec
Plate 0.176 sec – 52.0 sec
Initial Delay
Adjusts the time that elapses between the direct,
original sound and the initial reflections that follow
it.
Range: 0.1 msec – 200.0 msec
Decay
Adjusts the characteristic of the envelope from
the moment the reverberation starts to the
moment it attenuates and stops.
Range: 0 – 63
Panel Controls for the Software Programs
Room Size
Adjusts the size of the simulated room. This
parameter links to Reverb Time.
Range: 0 – 31
Diffusion
Adjusts the spread of the reverberation.
Range: 0 – 10
HPF
Adjusts the cutoff frequency of the high pass filter.
Range: 20 Hz – 8.0 kHz
LPF
Adjusts the cutoff frequency of the low pass filter.
Range: 1.0 kHz – 20.0 kHz
Hi Ratio
Adjusts the duration of reverberation in the high
frequency range by using a ratio relative to the
Reverb Time. When you set this parameter to 1,
the actual specified Reverb Time is fully applied
to the sound. The lower the value, the shorter the
duration of reverberation in the high frequency
range.
Range: 0.1 – 1.0
Low Ratio
Adjusts the duration of reverberation in the low
frequency range by using a ratio relative to the
Reverb Time. When you set this parameter to 1,
the actual specified Reverb Time is fully applied
to the sound. The lower the value, the shorter the
duration of reverberation in the low frequency
range.
Range: 0.1 – 1.4
Low Freq
Adjusts the frequency of the Low Ratio.
Range: 22.0 Hz – 18.0 kHz
OPEN/CLOSE
Opens and closes the window which adjusts the
reverb settings.
Graph
Indicates the characteristics of reverberation. The
vertical axis indicates the signal level, the
horizontal axis indicates the time, and the Z-axis
indicates the frequency. You can adjust the
characteristics of reverberation by dragging the
handles in the graph.
OUTPUT (VST Plug-in version only)
Indicates the output level of the REV-X.
UR824
Operation Manual 21