Panel Controls And Terminals (Details); Rear Panel - Steinberg UR 824 Operation Manual

Panel Controls and
Terminals (Details)

Rear Panel

DC IN 16V
For connection to the AC power adaptor.
Grounding screw
For connection to a ground wire.
If you have a problem with hum or noise, use this
terminal to connect to ground. The noise may be
reduced.
USB2.0 (USB port)
For connection to a computer.
WCLK switch
Switches between IN and OUT for the upper
WCLK terminal.
WCLK IN (OUT)/OUT (BNC connector)
For connection to the device which transmits and
receives the word clock.
OPTICAL A/B IN/OUT (optical)
For connection to a digital audio device.
You can select the format of the OPTICAL A/B
between ADAT and S/PDIF. To select the format,
use the "Setup Window" (page 12) in the section
"dspMixFx UR824" or the "Settings Window"
(page 18) in the section "Dedicated Windows for
Cubase Series."
You can select the output signal of the OPTICAL
A/B OUT. To select the output signal, use the
"Setup Window" (page 12) in the section
"dspMixFx UR824" or the "Output Routing
Window" (page 17) in the section "Dedicated
Windows for Cubase Series."

Panel Controls and Terminals (Details)

LINE OUTPUT 1–8 (phone type,
balanced/unbalanced)
For connection to monitor speakers. When the
monitor speakers have a balanced input, connect
them with a balanced cable.
You can select the output signal of LINE OUTPUT
1–8. To select the output signal, use the "Setup
Window" (page 12) in the section "dspMixFx
UR824" or the "Output Routing Window" (page
17) in the section "Dedicated Windows for
Cubase Series."
MIC/LINE INPUT 3–8 (XLR/phone type,
balanced/unbalanced)
For connection to a microphone or digital
instrument.
UR824
Operation Manual 4