Rev-X - Steinberg UR 824 Operation Manual

Equalizer
Equalizer Curve
This graph indicates the characteristics of the 3-
band equalizer. The vertical axis indicates the
gain, and the horizontal axis indicates the
frequency. You can adjust LOW, MID, and HIGH
by dragging each handle in the graph.
LOW F
Adjusts the center frequency of the low band.
Range: 20.0 Hz – 1.00 kHz
LOW G
Adjusts the gain of the low band.
Range: -18.0 dB – +18.0 dB
MID Q
Adjusts the band width of the middle band.
Range: 0.50 – 16.00
MID F
Adjusts the center frequency of the middle band.
Range: 20.0 Hz – 20.0 kHz
MID G
Adjusts the gain of the middle band.
Range: -18.0 dB – +18.0 dB
HIGH F
Adjusts the center frequency of the high band.
Range: 500.0 Hz – 20.0 kHz
HIGH G
Adjusts the gain of the high band.
Range: -18.0 dB – +18.0 dB
EQUALIZER On/Off
Turns the equalizer on (lit) and off (dark).
Panel Controls for the Software Programs

REV-X

This is the window for configuring the REV-X
settings. Three types of REV-X are available: Hall,
Room, and Plate.
NOTE
•The REV-X equipped with the device and REV-X of
the VST Plug-in version have the same parameters.
However, the "OUTPUT" and "MIX" parameters are
only available in the VST Plug-in version.
•When using the REV-X on Cubase series
programs, you can share the settings between the
built-in REV-X and the REV-X of the VST Plug-in
version as a preset file.
•When using the built-in REV-X on Cubase series
programs, turn on the "Direct Monitoring" setting in
the program.
•When assigning the REV-X of the VST Plug-in
version to the effect slot on Cubase series
programs, select it from the "Reverb" category (in
the case of the default settings).
•The built-in REV-X is equipped with an "FX Bus"
which is used for sending the signal from DAW
software to the REV-X. For example, to send the
recorded audio data to the REV-X, you can check
the sound with the REV-X, which is used for
monitoring during the recording.
Screenshot
How to Open the Window
From Dedicated Windows for Cubase
Series
•Click "REV-X Edit" (page 16) in the section "Input
Settings Window."
•Click "REV-X Edit" (page 16) in the section "Reverb
Routing Window."
Operation Manual
UR824
20