Connecting The Mic Preamp - Steinberg UR 824 Operation Manual

8.
Click "Record" to start the recording.
9.
After finishing the recording, click "Stop" to
stop it.
10.
Turn "Monitor" off (dark) for the audio track.
11.
Click the Ruler to move the project cursor to
the desired point for starting playback.
12.
Click "Play" to check the recorded sound.
When listening to the sound over monitor
speakers, adjust the output signal level by the
OUTPUT LEVEL knob on the device.
Operation is now completed.
Programs Other Than Cubase Series
1.
Launch your DAW software.
2.
Open the dspMixFx UR824.
For instructions on how to open the dspMixFx
UR824, refer to the section "How to Open the
Window" (page 9).
3.
Adjust the input signal level of the
microphone by the INPUT GAIN knob on the
device.
Adjust the input signal level so that the SIG/
PEAK lamp flashes dimly in red.
4.
Adjust the output signal level of the
headphone by the PHONES knob on the
device.
5.
Set the Channel Strip settings and REV-X
settings on the dspMixFx UR824.
6.
Start recording on your DAW software.
7.
After finishing recording, stop it.
8.
Playback the newly recorded sound to
check it.
Operation is now completed.

Connecting the Mic Preamp

This section shows how to increase the number of
analog input channels you can record by
connecting an eight-channel mic preamp. In this
example, you can record via up to sixteen channels
by connecting up to sixteen mics to the devices.
Use the OPTICAL A IN (ADAT) on the device to input
the audio signal, and use the WCLK OUT on the
device to output the word clock signal to the mic
preamp.
Connection Example
Computer
Mic Preamp
Usage Examples
Monitor speakers
Operation Manual
UR824
24