Table of Contents
Advertisement
Getting Started
System Administration Menu
12
The parameter changes noted below require the system to be reset before
they are recognized.
Ethernet Parameters
Store and Forward
Cut-Through
Collision is Indicated on Amber
Transmit is Indicated on Amber
1.
Connect the serial port of your terminal or PC to the RS232 console port
located on the front panel. For a PC connection, use a standard 9-pin serial
cable.
2.
Access your terminal, or use the terminal emulator program in Microsoft
Windows.
3.
Press the
<RETURN>
of the appropriate baud rate.
4.
From the Main Menu, open Omega's System Administration
submenu by entering the letter
You do not need to configure Omega if your default terminal is as follows: Data
bits: 8, Stop bits: 1, Parity: 0, Connector: Com1/Com2 (PC/terminal dependent)
ATM Parameters
Sonet
SDH
Internal clocking LED
External (loop) clocking LED
Unassigned cells idle cells
key several times. This will ensure auto configuration
.
S
NOTE
Advertisement
Table of Contents
