Get; Put - Allied Telesis AT-4016TR Operation Manual

Get

Put

An image file uses a binary format. Configuration data uses an ASCII format.
The switch, however, has the ability to differentiate between the two formats
and, once differentiated, accepts and places this data in the correct place.
Not all configuration fields apply to all products. This file includes
configuration data for AT-S7 (4016 with PVC's), AT-S6 (3690), AT-S9 (TS95)
with PVC's and AT-S13(4016 with SVC's). Exceptions are noted.
To obtain a current image for an AT-4016TR/AT-4016F or AT-TS95TR
respectively, enter either:
tftp get image.s7 123.0.0.5 ATS7 octet
tftp get image.s9 123.0.0.5 ATS9 octet
The switch will respond to a TFTP "get" request by transferring an image file
of the software currently executing in that unit to the requesting host. This
enables you to download the software onto another host system.
The switch will respond to a TFTP "get" request by transferring a binary
image of the software currently executing in that unit to the requesting host.
This enables you to upload the software onto the host system. The host
computer should then save the uploaded binary program image into a file
without otherwise modifying it in any way.
When you receive a "get" file from a device that has had its default
configuration values changed, you receive only those parameters, not the
entire configuration.
A TFTP configuration field "put" file involves the use of any, or all,
configuration parameters.
To download the image file for an AT-4016 or AT-TS95TR respectively:
tftp put image.s7 123.0.0.5 ATS7 octet
tftp put image.s9 123.0.0.5 ATS9 octet
Once the file is placed on the switch, downloading procedures are initiated.
The switch responds to a TFTP 'put' request by accepting program data from
the sending host. The system will write the new program image into its non-
volatile memory. When the TFTP session is complete, the system will reboot
itself and begin executing the new program.
The switch will not accept a TFTP "put" request if a PCMCIA card or
Firmware Cassette is installed.
AT-S7/AT-S9 Operations Manual
NOTE
NOTE
77