Table of Contents
Advertisement
Installation
Installing the Switch on a Table or Desktop
If you are rackmounting an AT-FS716 or AT-FS724i switch, refer to
"Rackmounting the Switch" on page 11.
Note
The AT-FS716E switch can only be use on a table or desktop.
To install the switch on a table or desktop, perform the following procedure:
1. Remove all equipment from the packaging and store the packing material
in a safe place. In the event a problem occurs and you need to return the
unit, please use as much of the original shipping material as possible.
2. Attach the four protective feet to the bottom of the unit. See Figure 5.
3. Place the switch on a flat, secure surface leaving ample space around the
switch for ventilation.
4. Apply power to the switch by plugging the AC/DC power adapter into an AC
power outlet, then plug the DC connector to the power receptacle located on
the back of the switch.
5. Verify that the POWER LED is green. If the LED is OFF, refer to
"Troubleshooting" on page 15.
Note
The switch performs a self-diagnostic test upon power up. This takes
about 20 seconds to complete.
6. Connect the twisted pair cables to a twisted pair ports on the switch and on
the end-nodes.
7. Power ON the end-nodes connected to the switch.
10
Figure 5 Attaching the Rubber Feet
Hide quick links:
Advertisement
Table of Contents
