Printer Configure Menu - HP 8590 E-Series User Manual

3. Referring to Figure 6-9 select the printer configuration for your spectrum analyzer by
pressing the appropriate keys:
P r i n t Config
PRINTER SETUP
S e t C o l r P r i n t e r
Set B&W Printer
HP B&W PRINTER
HP B&W DJ540
SML LRG
EP MX80
6-12 Printing and Plotting
Figure 6-9. Printer Configure Menu
Press this key to access the configuration menu.
Press this key to access the printer configuration menu.
Press this key to send a PRINTER RESET command to the printer.
This will cause a form feed if any data has been sent to the printer
since the last form feed.
Press this key to print in color if the spectrum analyzer is connected
to a Hewlett-Packard compatible color printer, then select the
appropriate printer.
Selecting any Hewlett-Packard printer results in three printouts
per page. After three printouts the page will be in position to start
again at the top of the page if the printer's perforation skip is OFF
(see Figure 6-l).
One printout per page can be achieved by manually formfitting each
printout.
Press this key to print in black and white, then select appropriate
printer mode.
Press this key if the spectrum analyzer is connected to a
Hewlett-Packard compatible printer.
Selecting any Hewlett-Packard printer results in three printouts
per page. After three printouts the page will be in position to start
again at the top of the page if the printer's perforation skip is OFF
(see Figure 6-l).
One printout per page can be achieved by manually formfitting each
printout.
Press this key if the spectrum analyzer is connected to a
Hewlett-Packard DeskJet 540 printer.
Press this key if the spectrum analyzer is connected to a MX-80
Epson or other compatible g-pin print-head printer.
Pressing this key to underline SML will allow two printouts per page
and will print softkey labels if desired (see PRT MENU ON OFF ).
Pressing this key to underline LRG will allow only one printout per
page and will not print the softkey labels.