HP 8590 E-Series User Manual page 275

Requires Option
STATE
saves the current spectrum analyzer state on the memory card. To save
the current state, press STATE -+ CARD, use the numeric keypad to enter
a number, and press ENTER. If you want the file name of the stored data to
contain a prefix, press Change Prefix to enter a prefix before storing the
data. If the state data was stored using a prefix, the file name for the state
data consists of s(prefix)-(register number). If no prefix was specified, the file
name is s-(register number). If windows are being used, only the state of the
active window will be saved.
Front-Panel Key Access: m
saves the current spectrum analyzer state in the selected state register. To save
STATE
the current state, press STATE + INTRNL , and use the numeric keypad to
enter a state register number (valid state register numbers are 1 through 8). If
windows are being used, only the state of the active window will be saved.
Front-Panel Key Access: ISAVE]
sets the frequency at the right side of the graticule. The left and right sides
STOP
of the graticule correspond to the start and stop frequencies. When these
frequencies are activated, their values are displayed below the graticule in
place of center frequency and span.
Front-Panel Key Access:
sets the default settings for the units used in the linear and the logarithmic
STOR PWR
modes when the instrument is powered on. The settings for the units can
ON UNITS
be changed during normal instrument operation but they will return to the
default settings when the instrument is powered on again. This is a service
calibration function. Refer to the service guide for more information.
Front-Panel Key Access: (CAL)
disables the two 20 dB step-gain amplifiers on the Al2 Amplitude Control
STP GAIN
assembly. This is a service diagnostic function and is for service use only.
ZERO
Front-Panel Key Access: a
accesses the softkey menu used for selecting screen title or prefix characters
S through X.
Front-Panel Key Access: a), (w), (DISPLAY), [RECALL], or m
accesses the sweep-time menu and accesses the sweep-time softkey functions
SWP TIME AUTO MAN and SWEEP CONT SGL.
105 only
Option
The [m] key also accesses the GATE ON OFF softkey which turns on the
gate function and the Gate Control softkey which accesses the gate menus.
switches the spectrum analyzer between the continuous-sweep mode and
SWEEP
the single-sweep mode. If the spectrum analyzer is in single-sweep mode,
CONT SGL
SGL is underlined. Press (SGL-] to enable a sweep when in single-sweep
mode. When continuous-sweep mode is in use, one sweep follows another as
soon as it is triggered. Pressing C-1, turning the power on, and pressing
PRESET SPECTRUM , all select continuous sweep.
Front-Panel Key Access: [SWEEP) or (TRIG)
7-82 Key Descriptions
003 the HP 859OL, HP 8592L, and HP 8594L.
for