HP 8590 E-Series User Manual page 257

Option 041 or 043 only.
selects the position of the plotter output. The highlighted portion of the
Front-Panel Key Access: @Zi'@
Option 041 or 043 only.
PLT MENU
allows the softkey labels to be plotted along with the spectrum analyzer
ON OFF
display. This function operates when the IcoPv] key is used in a plot
configuration. The PLT MENU ON OFF function is set to OFF when
DEFAULT CONFIG is pressed.
Front-Panel Key Access: C-1
Option 041 or 043 only.
ig
accesses the menus used by Option 041 (HP-IB and Parallel Interface) and
Conf
Option 043 (RS-232 and Parallel Interface) to select plotter options. See the
Front-Panel Key Access: (CONFIG)
Option 041 only.
PLT PORT
allows you to select between HP-IB or parallel plotter ports.
HPIB PAR
Option 043 only.
PLT PORT
allows you to select between serial or parallel plotter ports. The BAUD RATE
SER PAR
Option 041 or 043 only.
PLTS/PG
allows you to plot a full-page, half-page, or quarter-page output. Selecting two
1 2 4
plots per page requires a plotter that has the rotate command (RO). The plotter
will be set to a full-page output when DEFAULT CONFIG is pressed.
Front-Panel Key Access: [CONFIG)
Option 041 or 043 only.
allows you to plot a full-page, half-page, or quarter-page output to an
ON OFF
HP LaserJet printer. This softkey can be accessed by pressing I-), then
Plot Conf
Front-Panel Key Access: C-1
specifies a limit value for one coordinate point,
POINT
specifies a limit value for a single frequency or time. For an upper limit line,
a POINT segment is indicated by a line drawn vertically from the coordinate
point to a point off the top of screen. For a lower limit line, a POINT segment
is indicated by a line drawn vertically from the coordinate point to a point
off the bottom of screen. The POINT segment type is generally used as the
last segment in the limit-line table. However, if the last segment in the table
is not of the POINT segment type, an implicit point is automatically added at
the right-hand side of the screen. If a visible POINT segment at the right-hand
edge of the display is not desired, add an explicit last-point segment to the
limit-line table that is higher in frequency than the stop frequency.
Front-Panel Key Access: (-1
ig .
so that segment
a POINT