HP 8590 E-Series User Manual page 272

SET allows you to set the date of the real-time clock. Enter the date in the
YYMMDD format using the number keypad and press C-1. Valid year
DATE
values are 00 through 99. Valid month (MM) values are from 01 to 12, and
valid day values are from 01 to 31.
Front-Panel Key Access: @%iZ]
SET
allows you to set the time of the real-time clock. Enter the time in 24 hour,
TIME HHMMSS format, using the number keypad and pressing [ENTER]. Valid hour
(HH) values are from 00 to 23. Valid minute (MM) and second (SS) values are
from 00 to 59.
Front-Panel Key Access: c-1
accesses the menu used to set up parameters specific to the power
Setup
measurements.
If another front-panel key is pressed, exiting the power menus, press the
Front-Panel Key Access:
changes the sweep control to single sweep if the spectrum analyzer is in the
continuous sweep mode. It executes a sweep after the trigger condition is met.
SHOW displays the number and description of the options installed in your spectrum
analyzer, the instrument model number of the spectrum analyzer, the last five
OPTIONS
digits of the spectrum analyzer serial number, and the firmware revision.
Pressing SHOW OPTIONS changes the softkey label to EXIT SHOW . Press
EXIT SHOW to erase the SHOW OPTIONS function information.
Pressing
show combination options such as Option 301, instead both options 101 and
102 will be displayed.
Front-Panel Key Access: CCONFIG]
SIGNAL
activates an FFT marker that must be put on a signal to verify that it is not
being displayed at the wrong frequency due to aliasing. Once the marker is on
ID
the signal press SIGNAL ID again to initiate the signal identification function.
The signal should move half of a division to the right for 2 seconds. A marker
will be put at the frequency that the signal should move to. If the marker
appears on the signal when it is shifted, then the frequency readout of the
signal is correct. Sweep time limitations may alter or stop the function from
executing.
If the marker or the signal is less than half of a division from the right side of
the display before
correctly and a warning message can be displayed.
Front-Panel Key Access: (-1
key twice to return to the last power menu that was being used.
SHOW OPTIONS
displays the individual option numbers. It will not
SIGNAL ID
is pressed, then the routine may not function
(YY)
Key Descriptions 7-79