HP 8590 E-Series User Manual page 233

allows you to purge all user state registers, all user trace registers, all mode
ERASE
registers, the editor buffer, Group delay normalization, all DLP memory, and
MEM ALL
all microprocessor stack data. The stack pointer is set to its power-up value.
No system globals are erased and the calibration data is preserved. Pressing
ERASE MEM ALL causes a message to appear on the spectrum analyzer screen:
If youare sure,Press key againtopurgedata. Press ERASE MEM ALL
again if you want to dispose of all user memory. Press any other softkey if you
do not want to dispose of all user memory.
Note
ERASE MEN ALL ignores the state of the SAV LOCK. So, even if STATES and
TRACES are locked, they will still be erased by ERASE MEM ALL .
Front-Panel Key Access: C-1
allows you to dispose of any data or programs stored on the memory card by
ERASE
MEM CARD formatting it. This is the same as FORMAT CARD . Pressing
and then pressing ERASE MEM CARD causes a message to appear on the
spectrum analyzer screen:
Press ERASE MEM CARD again if you want to dispose of the CARD's memory.
Press any other softkey if you do not, want to dispose of the CARD's memory.
Note
Use DELETE FILE to selectively delete stored programs or variables from
spectrum analyzer memory.
Front-Panel Key Access: (75i%iYY]
allows you to purge all the user state registers 1 through 9. Pressing
ERASE
Dispose User Mem and then
appear on the spectrum analyzer screen: If you are sure, Press key again
to purge data. Press ERASE STATEALL again
user state registers. Press any other softkey if you do not want to dispose of
user state registers.
Note
If SAVE LOCK ON OFF is set to (ON), this function is disabled.
n
spectrum analyzer memory.
Front-Panel Key Access: [m]
If you are sure, Press key againtopurge data.
pressing ERASE STATEALL causes a message to
if you want to dispose of the
Dispose User Mem