Menu Navigation
Basic menu navigation is accomplished by selecting the desired option number and then
pressing E
Help screen, press the question mark ( ? ) key.
General Keyboard Commands
Table 7 shows the general keyboard commands for the TR DDS‐DP system.
Keyboard
Command
B
ACKSPACE
E
NTER
C
TRL
C
TRL
E
SC
Remote Provisioning and Diagnostics
TR DDS‐DP provides remote access to provisioning and diagnostics via ADTRAN Digital
System 6 Message (DS6) protocol. The TR DDS‐DP can also be accessed via the craft interfaces
on the Total Access 1500 SCU. The following section provides detailed provisioning and
diagnostic information.
• Control Protocol
• Provisioning and Status DS6
• Electronic Provisisioning
Control Protocol
Remote access to provisioning and status information is accomplished using either ADTRAN
Digital System 6 Message protocol defined in Control and Diagnostic Procedures Practice, Section
6032991‐6, or through the craft interface on the Total Access 1500 SCU. Digital System 6 is
supported by the TPI 108/109 and 105 portable test sets and is supported by Hekimian React
2001 Revision 1900 remote test system. The Total Reach DDS network elements comply with
ANSI T1.107‐1995, "Digital Hierarchy Format Specifications Annex G" which allows remote
provisioning, querying, and performance monitoring via in‐band control of network
elements.
NOTE
The REACT 2001 GUI software Release 1.900 supports ANSI T1.107‐1995.
Remote access is accomplished using a defined set of in‐band DS0 byte sequences similar to
the latching loopback sequence. Commands issued via the test system are recognized by the
individual channel unit, which responds with the appropriate byte sequences. These in‐band
61180105L1-5C
. To return to the previous menu, press the E
NTER
Table 7. General Keyboard Commands
Description
This keyboard command deletes the character to left of the cursor during key‐
board input.
(or Return)
This keyboard command terminates input.
+R
(Control and r)
This keyboard command refreshes the display.
+Z
(Control and z)
This keyboard command forces the terminal menu display to the top level.
(Escape)
This keyboard command clears partial input or return to the previous menu.
Remote Provisioning and Diagnostics
(escape) key. To access the System
SC
15