Fitting - Miele KM 440 Operating Instructions Manual

Installation instructions

Fitting

Fix the special spring clamps b sup-
plied at the marked positions by la-
ying them on the upper edge of the
cut-out and then securing them with
the 3.5 x 25mm screws supplied.
24
Granite worktops
Place the special clamps b in posi-
tion and then secure with strong
double sided tape. In addition, coat
with silicone sealant.
The screws are not necessary for
granite worktops.
Guide the hob cable down through
the cut-out and connect the hob to
the power supply.
Position the hob. Then with a hand
on each side of the hob press down
on the edges evenly until it clicks
into place.
When doing this take care that the
edge of the hob is lying flat above
the worktop on all sides.
(The hob can now only be removed
with a special tool).
Shelf fitted underneath
If there is a shelf underneath the hob
there must be a minimum distance of
55 mm between the hob and the shelf.
There must be an additional air gap of
10 mm between the rear wall and the
back of any shelf.