Canceling A Communication; Canceling A Memory Transmission (During Scanning); Canceling A Memory Transmission (During Transmission) - Triumph Adler DCC 2520 Instruction Handbook Manual

Canceling a Communication

You can cancel a communication even if it is already in progress. The methods for canceling a
communication differ depending on whether that communication is a fax transmission or a fax
reception, and whether that transmission was initiated using the Memory Transmission mode or the
Direct Feed Transmission mode. The following contains explanations on the various methods used
for canceling communications.

Canceling a Memory Transmission (during scanning)

If you want to cancel a Memory Transmission during
scanning of the documents, simply press the
Stop/Clear key. The document that is currently being
scanned will be ejected and the touch panel will return
to the initial mode settings. If there are any documents
left in the Document Processor, remove them from the
document table.

Canceling a Memory Transmission (during transmission)

If you want to cancel a Memory Transmission in which scanning all of the documents has been
completed and the dialing or transmission operation has already begun, perform the following
procedure.
1 Press the [Status] ([Act status]) key or
the Stop/Clear key in the bottom right of
the touch panel.
The status of the communication
currently in progress will appear in the
message display.)
2 Press the [Stop] key. The touch panel
will return to the initial mode settings.
NOTE: If you attempt to cancel a transmission that is scheduled to multiple destinations (such as a
Broadcast Transmission) and there were destinations still remaining to be transmitted to, a
message will appear in the message display asking whether or not you want to continue the
transmissions to the remaining destinations. To continue, press the [Yes] key. To stop the
transmissions, press the [No] key.
for fax transmission.
riginal & assign destination.
TX
Abbrev.
setting
Application
Register
Check Status of Fax
Status of Fax
Port
Doc #: 020.
Dialing.
03.
Stop
Fax Operation (Basic Use)
Memory usage:
OCT-11-2005 16:00
Dest.
check
Re-dial
On-hook
Memory TX
Auto RX
Print Report
Status
Print
.0%
Memory
OCT-11
2-13