2620A, 2625A
Users Manual
Alarm evaluation is not carried out for a channel if:
PRESS
THESE
BUTTONS:
TO
SELECT
FROM
THESE
CHOICES:
Alarm Parameters
PRESS
THESE
BUTTONS:
TO
SELECT
FROM
THESE
CHOICES:
Note 1. Alarm limit can be cycled through HI, LO, and OFF without resetting the alarm value.
Note 2. Multiplier definitions (available for each decimal point position):
Alarm Indications
Generally, the ALARM annunciator is dimly lit whenever the last measurement on any
channel was found to be in alarm. When the displayed channel is in alarm during review,
the ALARM annunciator flashes, LIMIT is lit, and additional annunciators show the
alarm limit as and/or and the alarm sense as "HI" or "LO".
3-10
The limit sense is changed to "OFF". Alarm checking and the alarm limit values are
re-enabled by setting limit sense to "HI" or "LO".
An open thermocouple has been detected on that channel (thermocouple temperature
function only).
Channel
0
1
.
.
20
Alarm
Limit
(Note 1)
OFF
HI
LO
Table 3-7. Alarm Selection
Alarm
Complete Alarm
Parameters (Below)
or
Sign,
Decimal
Value
Point
Position
0000
0.0000
00.000
000.00
0000.0
m .001
x1 1.0
k 1000
M 1000000
Multiplier (Note 2)
m
x1
k
M