Mitsubishi F5MR1 Manual page 55

22A-8-2
MANUAL TRANSMISSION (E - W) -
E
E
Mitsubishi Motors Corporation Mitsubishi Motors Corporation
REASSEMBLY SERVICE POINTS
"AAINPUT SHAFT BEARING/CLUTCH HOUSING END
(1) Locate the bearing on the input shaft.
(2) Tap the bearing with a drift until it abuts against the stop
RMT0056
"BA INPUT SHAFT BEARING/TRANSMISSION CASE
(1) Fit the shim.
(2) Fit the bearing.
RMT0057
May 1996
May 1995
Input Shaft <F5MR3>
INSTALLATION
on the input shaft.
END INSTALLATION
NOTE
In the case of old bearings: Fit the old shim.
In the case of new bearings: fit a shim with a thickness
of 1.6 mm.
PWEE9508-B PWEE9508 Added