Mitsubishi F5MR1 Manual page 49

MANUAL TRANSMISSION (E - W) -
1
MD998717
E
E
Mitsubishi Motors Corporation Mitsubishi Motors Corporation
"CA SPEEDOMETER DRIVE GEAR INSTALLATION
(1) Introduce the shaft together with the speedometer drive
(2) Press the shaft firmly into place (snap connection).
(3) Smear liberal amounts of grease on the gears.
"DA LARGE BEARING INSTALLATION
(1) Coat the mating face with the specified sealant.
(2) Fit the bearing by tapping it in with a plastic - hammer.
(3) Make sure that the bearing abuts accurately against its
"EA OUTPUT SHAFT BEARING INSTALLATION
(1) Fit the oil baffle 1.
(2) Coat the mating face with the specified sealant.
MB990938
(3) Tap in the bearing with handle MB990938 and installer
(4) Stake the lock washers (upset: about 1 mm) with a centre
MB990931
"FA OUTPUT SHAFT BEARING INSTALLATION
MB990938
(1) Fit the oil baffle.
(2) Coat the mating face with the specified sealant.
(3) Tap in the bearing with handle MB990938 and installer
MB990931
RMT0051
"GA INPUT SHAFT BEARING INSTALLATION
(1) Coat the mating face with the specified sealant.
(2) Locate the bearing so that the oil passages of the bearing
(3) Press in the bearing with installer MD998717.
May 1996
May 1995
Clutch Housing
gear in the clutch housing and note the position of the
speedometer drive gear relative to the shaft.
seating.
NOTE
The open side of the bearing must be facing inwards.
MB990931.
punch.
NOTE
The bearing must be flush with the housing.
MB990931.
NOTE
The bearing must be flush with the housing.
and the housing are opposed.
NOTE
The bearing must be flush with the housing.
PWEE9508-B PWEE9508
22A-6-5
Added