Mitsubishi F5MR1 Manual page 27

MANUAL TRANSMISSION (E - W) -
14
25 Nm
25 Nm
E
E
Mitsubishi Motors Corporation Mitsubishi Motors Corporation
"UA 5TH GEAR WHEEL INSTALLATION
(1) Apply a few drops of sealant (Loctite 242) to the gear
(2) Fit the gear wheel on the shaft.
(3) Press the gear wheel with the bolt and shim on to the
(4) Remove the bolt and shim.
"VA SYNCHRONIZER HUB/SYNCHRONIZER SPRING/
13
(1) Fit the hub in the synchronizer sleeve.
(2) Locate the synchronizer spring 12 at the bottom in the
(3) Locate the selector fork 13 in the synchronizer hub 14
12
(4) Fit the hub over the input shaft and at the same time
(5) Press the hub on to the input shaft with the old lock
(6) Remove the lock nut.
"WA
135 Nm
(1) Press the synchronizer hub into 5th gear.
80 Nm
(2) Push down the reverse idler gear shaft.
15
(3) Fit and tighten a new lock nut.
(4) Locate the shim 15.
(5) Apply a few drops of sealant (Loctite 242) to the bolt.
(6) Fit and tighten the bolt.
"XA SPRING PIN INSTALLATION
(1) Raise the selector fork.
(2) Fit a new (long) spring pin in the selector fork.
(3) Tap in the spring pin to its full extent.
(4) Check for correct operation.
"YA O-RING/REAR COVER/BOLT INSTALLATION
(1) Place a new O-ring on the transmission case.
(2) Locate the rear cover carefully on account of the oil guide.
(3) Fit and tighten the bolts.
25 Nm
May 1996
May 1995
Transmission
wheel.
output shaft.
SYNCHRONIZER SLEEVE/5TH SPEED SHIFT FORK
INSTALLATION
recess.
with the long side facing towards the transmission case.
slide the selector fork over the shift rail assembly.
nut.
LOCK NUT/SHIM/BOLT INSTALLATION
NOTE
Put the gears in neutral.
NOTE
The slit in the spring pin must be in axial alignment with
the reverse idler gear shaft.
PWEE9508-B PWEE9508
22A-3-15
Added