MANUAL TRANSMISSION (E - W) -
3
6
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
"GA INTERLOCK PLUNGER INSTALLATION
(1) Fit the dowel pin.
RMT0015
(2) Fit the two short interlock plungers.
RMT0016
"HA INPUT SHAFT/OUTPUT SHAFT/3RD AND 4TH SHIFT
(1) Locate the 1st and 2nd gear selector fork 3 in the
4
(2) Locate the shift rail assembly 4 together with the selector
5
(3) Locate the three shafts in the clutch housing.
"IA INPUT SHAFT INSTALLATION
NOTE
When fitting the input shaft, take care not to damage the
oil seal.
RMT0017
"JA 1ST AND 2ND SHIFT RAIL ASSEMBLY/SPRING PIN
(1) Fit the small interlock plunger 6 in the shift rail assembly.
(2) Introduce the shift rail assembly 7 through the selector
(3) Check the operation of the interlock plungers.
7
(4) Fit a new (short) spring pin in the selector fork.
May 1996
May 1995
Transmission
RAIL ASSEMBLY INSTALLATION
synchronizer hub.
fork 5 in the synchronizer sleeve.
NOTE
When fitting the input shaft, take care not to damage
the oil seal.
INSTALLATION
fork in the housing.
NOTE
The slit in the spring pin must be in axial alignment with
the shift rail assembly.
PWEE9508-B
PWEE9508
22A-3-11
Revised