Mitsubishi F5MR1 Manual page 33

MD998801
A
MB996013
E
E
Mitsubishi Motors Corporation Mitsubishi Motors Corporation
MANUAL TRANSMISSION (E - W) -
RMT0028
RMT0029
B
RMT0030
RMT0031
May 1996
May 1995
AJ" BEARING CUP/OUTPUT SHAFT REMOVAL
(1) Place the output shaft on a soft surface.
(2) Tap the bearing cup partway off the output shaft with
a chisel.
(3) Locate the bearing remover MD998801 behind the bearing
cup.
(4) Press the output shaft out of the bearing cup.
PREPARATION BEFORE REASSEMBLY
<F5MR3>
BEARING BUSHES INSTALLATION
(1) Place the three bearing bushings on a hot plate.
(2) Heat the bearing bushings to 150
REASSEMBLY SERVICE POINTS
"AA 1ST GEAR WHEEL INSTALLATION
Locate the gear wheel together with the synchronizer ring
on the shaft.
"BA SYNCHRONIZER SPRINGS INSTALLATION
(1) Place the hub on a workbench.
(2) Position the two synchronizer springs so that the wider
sections engage the recesses in the hub.
(3) Locate the synchronizer sleeve on the hub.
NOTE
Take special note of the engaging sleeve lugs.
"CA OUTPUT SHAFT BEARING CUP INSTALLATION
(1) Place the output shaft under a press and support the
1st gear wheel.
(2) Press the bearing cup on to the output shaft with bearing
drift MB996013.
PWEE9508-B PWEE9508
Output Shaft
C maximum.
°
22A-4-5
Added