22A-3-8
MANUAL TRANSMISSION (E - W) -
MB990938
MB990931
MB996012
E
E
Mitsubishi Motors Corporation
Mitsubishi Motors Corporation
AR" OUTPUT SHAFT REAR BEARING/INPUT SHAFT
(1) Open the snap rings with a pair of pliers.
(2) Tap out the bearings towards the inside of the transmission
(3) Remove the two snap rings.
AS" REAR BEARING CUP OUTPUT SHAFT/REAR
(1) Tap the bearing cups out of the transmission case with
RMT0011
ADJUSTMENT BEFORE REASSEMBLY
<F5MR3>
CALCULATE THE PRE-TENSION OF THE INPUT AND
OUTPUT SHAFTS WITH NEW BEARINGS
(1) Introduce the input shaft and the output shaft in the clutch
(2) Place the transmission case on the clutch housing, insert
(3) Locate the mounting plate MB996012 on the tripod joint
(4) Locate the magnetic base together with clock gauge on
Input shaft
(5) Rotate the input shaft a few times.
(6) Raise the input shaft at the clutch end and read off the
Example
pre-tension
value
RMT0012
shim thickness
measured value
Select:
A: a shim with a thickness of 1.10 mm
B: a shim with a thickness of 1.50 mm
May 1996
May 1995
Transmission
REAR BEARING/SNAP RING REMOVAL
case with a plastic-tip hammer.
BEARING CUP INPUT SHAFT REMOVAL
handle MB990938 and bearing installer MB990931.
housing.
a few retaining bolts around the shafts and tighten the
bolts.
housing and secure it with a bolt.
the mounting plate.
value indicated by the clock gauge.
Repeat this operation several times.
PWEE9508-B
PWEE9508
A
B
new
used
bearings
bearings
0.00 mm
- 0.03 mm
+0.60 mm +0.60 mm
+0.46 mm +0.46 mm
=1.06 mm =1.03 mm
Revised