Mitsubishi F5MR1 Manual page 35

3
E
E
Mitsubishi Motors Corporation Mitsubishi Motors Corporation
MANUAL TRANSMISSION (E - W) -
RMT0035
RMT0036
4
2
RMT0037
May 1996
May 1995
"GA 2ND GEAR WHEEL INSTALLATION
(1) Locate the gear wheel on the bearing bush.
(2) Fit the shim.
"HA 3RD GEAR WHEEL BEARING BUSH
INSTALLATION
(1) Locate the bearing bush so that the oil passages of the
bearing bush and the output shaft are opposed.
(2) Place the heated bearing bush, using a pair of gripping
pliers, over the output shaft on the shim.
NOTE
Allow the bearing bush to cool and then lubricate copiously
with transmission fluid.
"IA 3RD GEAR WHEEL INSTALLATION
(1) Locate the serrated ring 4 (thickness: 1.5 mm) with the
bevelled edge facing towards the gear wheel.
(2) Locate the gear wheel together with the synchronizer
ring on the shaft.
(3) Locate the serrated ring 2 (thickness: 1.5 mm) with the
bevelled edge facing towards the gear wheel.
(4) Fit a new snap ring 3.
NOTE
Make sure that the lugs of the synchronizer ring engage
the recesses in the synchronizer sleeve.
"JA 3RD GEAR WHEEL INSTALLATION
(1) Locate the gear wheel together with the synchronizer
ring on the bearing bush.
"KA 3RD - 4TH SYNCHRONIZER HUB INSTALLATION
(1) Place the hub on a workbench.
(2) Locate the synchronizer sleeve on the hub with the groove
for the selector fork facing up; see the illustration.
(3) Locate the three synchronizer springs together with the
rollers in the hub.
NOTE
Always use new synchronizer springs.
PWEE9508-B PWEE9508
Output Shaft
22A-4-7
Added