Mitsubishi F5MR1 Manual page 44

22A-5-6
MB996010
MB996010
E
E
Mitsubishi Motors Corporation Mitsubishi Motors Corporation
MANUAL TRANSMISSION (E - W) -
(7) Press the nut on to the threaded end with socket wrench
(8) Remove the counterhold.
(9) Rotate the differential a few times.
(10)Fit counterhold MB996005.
(11)Tighten the nut to 130 Nm.
(12)Remove the counterhold.
"GA SNAP RING INSTALLATION
(1) Locate the differential in the clutch housing.
(2) Place the clutch housing under a press and support the
(3) Using special tool MB996010, press the housing
(4) Now press the housing downwards, against the spring
(5) Fit the snap ring.
"HA OIL SEAL INSTALLATION
MB996010
(1) Pack the lip of the new oil seal with grease.
(2) Place the guide on the shaft and locate the oil.
(3) Fit the oil seal with drift MB996010.
(4) Fit a new O-ring.
May 1996
May 1995
Differential
MB996003 until it catches the thread and then tighten
the nut to 18 Nm.
differential.
downwards until it abuts against the stop.
pressure, until it is possible to fit the snap ring.
PWEE9508-B PWEE9508 Added