Mitsubishi F5MR1 Manual page 21

MANUAL TRANSMISSION (E - W) -
MB996012
MB990938
MB990933
E
E
Mitsubishi Motors Corporation Mitsubishi Motors Corporation
Output shaft
(7) Rotate the output shaft a few times.
(8) Raise the output shaft at the clutch end and read off
Example
pre-tension
value
RMT0013
shim thickness
measured value
Select:
A: a shim with a thickness of 2.15 mm
B: a shim with a thickness of 1.95 mm
(9) Remove the transmission case and the input shaft and
REASSEMBLY SERVICE POINTS
MB990938
"AA SNAP RING/INPUT SHAFT REAR BEARING/OUTPUT
MB990932
(1) Coat the mating faces in the transmission case with the
(2) Locate the two snap rings 1.
(3) Introduce the bearings from the outside of the transmission
1
(4) Open the snap rings with a pair of pliers and tap in the
(5) Remove the pliers.
(6) Now tap the bearings further into the transmission case
"BA INPUT SHAFT REAR BEARING CUP/OUTPUT
(1) Coat the mating faces in the transmission case with the
(2) Introduce the bearing cups from the inside of the
(3) Tap the bearing cup into the transmission case as far
RMT0014
May 1996
May 1995
Transmission
the value indicated by the clock gauge.
Repeat this operation several times.
NOTE
Always use the thickest shim in order to obtain the required
pre-tension value.
output shaft.
SHAFT REAR BEARING INSTALLATION
specified sealant.
case with the groove facing up.
bearings with a plastic-tip hammer until they are projecting
about 3 mm above the transmission case.
with handle MB990938 and bearing installer set
MB990932 until the snap rings slip into the grooves.
SHAFT REAR BEARING CUP INSTALLATION
specified sealant.
transmission case.
as the stop with handle MB990938 and installer
MB990933.
PWEE9508-B PWEE9508
A B
new used
bearings bearings
0.26 mm 0.06 mm
+1.60 mm +1.60 mm
+0.28 mm +0.28 mm
=2.14 mm =1.94 mm
22A-3-9
Revised