Mitsubishi Electric LAN CONTROL UTILITY Operation Manual page 11

4. Projector registration
Procedure B - Connection example 3 (where projectors are installed via a router)
To automatically detect projectors connected via a router, confirm the IP address in the projector network menu and
specify a range of IP addresses to search that particular IP address using "Detect Projector".
(1) Start up "ProjectorView Global+".
(2) Select "Detect Projector" from "Set Configuration" of the menu bar.
• "Detect Projector" window is displayed.
Item
A
Enable/Disable
B
Start IP Address
C
End IP Address
D
Search Projector
(3) Specify the projector search range by IP address (
( A ) of the search range.
• Up to 16 search ranges can be set. (Settings can be configured for each line of the search range.)
(4) To save the settings, click [OK]. To continue the projector search, click [Search Projector].
• When you click [OK], the search ranges you specify are saved and the "Detect Projector" window is closed.
• When you don't want to save the search ranges, click [Cancel] to close the "Detect Projector" window.
• After saving the settings, by selecting "Global Control" on the menu bar and then selecting "Search Projector",
you can perform automatic projector search within the search ranges you saved.
• The password is required when you are connecting the projectors for the first time. Authentication is
automatically performed from the second time onwards unless projectors are deleted from the list.
A B
D
Description
Select whether to enable or disable the search range specified on that line.
(The search ranges of which boxes are selected are enabled.)
Specify the IP address that is the start of the search range.
(You cannot specify an IP address that contains a range other than 1 to 254 for
the first and last octets and a range other than 0 to 255 for the second and third
octets.)
Specify the last octet of the IP address that is the end of the search range.
(You cannot specify a value that contains a number other than 1 to 254. In
addition, you cannot specify a value that is smaller than the last octet of the
search start IP address specified in step
The settings you made are saved and then the automatic projector search is
performed.
C
B
.)
B and C ) and check the Enable/Disable box
11