Night Mode Tab - Inter-Tel Attendant Console User Manual

Night Mode Tab

NOTE:
Only an Administrator can perform the night mode configuration and on and
off. All users have the ability to view the night mode status but does not be allowed to
put nodes in or out of night mode.
The Night Mode tab, shown below, allows an Administrator to configure what will
happen when the nodes are put in Night Mode. This tab also shows the night mode
status of each node for all users.
•
Night Mode Setup:
— Put all nodes in night mode: All nodes connected to the OAI Server are put
in and out of night mode.
— Put only my node in night mode: Only the operator's node is put in and out
of night mode.
— Put selected nodes in night mode: Allows you to choose what nodes to put
in and out of night mode from a list. The list will contain all the nodes that
the Attendant Console is communicating with and their locations.
®
Inter-Tel Attendant Console User Guide
19