Scene Mode; Select Scene; Value (Encoder/Slider Value) - Korg microKONTROL Owner's Manual

Operation–Scene mode

Scene mode

In Scene mode you can select and save scenes, load preset scenes, and
transmit and receive dump data.
Scene mode is divided into five pages.
Hold down the [SCENE] key; the main display will indicate "ScenePd?",
pads [1] through [12] – which you can use to select scenes – will light, and
the pad of the current scene will blink. Then press one of the following pads
to select a scene or enter a page for saving a scene, etc. Alternatively, you can
hold down the [EXIT] key and press the [SCENE] key; the main display will
indicate "ScenePad?" and the microKONTROL will wait for you to select a
page (Mode Lock). Now you can press a pad to select a page.
Pad No. Page
Pad [1]–[12]

Select Scene

Pad [13] Encoder/Slider Value
Pad [14] Dump
Pad [15] Preload
Pad [16] Write
About the OCTAVE SHIFT/CURSOR keys, [ENTER] key, and [EXIT]
key
On the [15] PRELOAD and [16] WRITE pages, you can use the OCTAVE
SHIFT/CURSOR [√]/[®] keys as cursor keys to move between
parameters.
When you press the [SCENE] key and a pad to enter one of these pages, the
key(s) for the direction(s) in which you can move will light green. You
cannot move in a direction in which the key is dark or lit red.
(Red) (Green)
: You can move toward the right to another parameter
(Green) (Red)
: You can move toward the left to another parameter
When you come to the last page, the [ENTER] key will blink. Press the
[ENTER] key to execute the Load or Write operation and return to Play
mode. If you decide to cancel, press the [EXIT] key.
52
Contents
Select a scene from internal memory. (☞p.52)
View the encoder and slider values. (☞p.52)
Save/load scenes to/from a computer. (☞p.53)
Load the preset scenes. (☞p.53)
Save a scene into internal memory. (☞p.54)
[1]...[12] Select Scene
Here's how to select one of the scenes stored in the microKONTROL's
internal memory.
1 Hold down the [SCENE] key and press the pad of the scene number
you want to use ([1]–[12]).
The pad will blink, and the main display will show the name of the
selected scene.
Release the [SCENE] key to return to Play mode.
When you turn on the power, the last-selected scene will be selected.
Be aware that if you have modified the settings of the currently selected
scene, re-selecting that scene will revert to the unmodified settings.
Loading a scene merely changes the internal settings of the
microKONTROL; it does not cause MIDI messages to be transmitted
from the USB connector or MIDI connector.
Never turn off the power while changing scenes; doing so may cause
the internal data to be damaged.

[13] VALUE (Encoder/Slider Value)

This shows the current values of the encoders and sliders in the sub-displays.
Before you use the Message mode snapshot function (☞p.43 "Message
mode–[2] SNAP (Snap message)"), you can use this to check the values of the
encoders and sliders.
1 Hold down the [SCENE] key and press pad [13].
While you hold down this key and pad, the main display will indicate
"VALUE" and the sub-displays will indicate the current encoder and
slider values.
The first three digits are the encoder value, and the last three digits are
the slider value.
Release the pad or the [SCENE] key to return to Play mode.