Pedal (Pedal Assignment) - Korg microKONTROL Owner's Manual

7 Press the OCTAVE SHIFT/CURSOR [®] key to proceed to "MIDI
Channel" (specify the MIDI channel).
(Green)
8 Use the [VALUE] dial or the pads to select the MIDI transmit channel.
The range is 1–16 (ch).
9 Press the OCTAVE SHIFT/CURSOR [®] key to proceed to "PAD
Type" (select the type of pad operation).
(Green)
Use the [VALUE] dial to select how the pad will operate.
10
Momt (Momentary)
If a control change is assigned to the pad, pressing the pad will
transmit the assigned control change message with a value of 127, and
releasing it will transmit a value of 0.
If a note message is assigned to the pad, pressing the pad will transmit
a note-on, and releasing it will transmit a note-off.
Tgle (Toggle)
If a control change is assigned to the pad, the assigned MIDI message
will be transmitted alternately with a value of 127 and a value of 0 each
time you press the pad.
If a note message is assigned to the pad, a note-on message and a note-
off message will be transmitted alternately each time you press the
pad.
(Green)
(Green)
11 Press the [ENTER] key.
The settings will be updated and you will return to Play mode.
In Play mode, pads to which a control change is assigned will be lit,
and pads to which a note message is assigned or for which NoAssign is
selected will be dark.
If you want to keep the new assignments, you must save them in Scene
mode. If you turn off the power or select a different scene without
saving, your changes will be lost. (☞p.54 "Scene mode–[16] WRITE")

[4] PEDAL (Pedal assignment)

In the Pedal assignment page you can assign a MIDI message to the pedal
connected to the rear panel PEDAL jack, and specify the MIDI transmit
channel etc.
The messages that you can assign to the pedal are: damper, sostenuto, soft
pedal, portamento, or a control change (CC#).
1 Hold down the [SETTING] key and press pad [4].
The [SETTING] key and pad [4] will light, and you will be in the Pedal
assignment page. The main display indicates "Message Select" (select
the MIDI message).
2 Use the [VALUE] dial to select the MIDI message that you want to
assign.
NoAssign
No MIDI message will be assigned to the pedal. If you select NoAssign,
the setting will be updated when you press the [ENTER] key. ☞Step 5
Damper
Assigns the Damper message (CC#64) to the pedal. This is also
sometimes called the Sustain Pedal message.
A value of 127 will be transmitted when you press the pedal, and a
value of 0 when you release the pedal.
When you operate the pedal in Play mode, the main display will show
"Dampr --".
Operation–Setting mode
29