Joystick-Y (Joystick-Y Assignment); Stick Sw (Joystick Switch Assignment) - Korg microKONTROL Owner's Manual

7 Use the [VALUE] dial or the pads to select the MIDI channel on which
the assigned MIDI message will be transmitted. The range is 1–16 (ch).
(☞p.4 "About the trigger pad functions–Input numerical values")
8 Press the OCTAVE SHIFT/CURSOR [√] key to return to "+X/–Y
Select," and use the same procedure to make settings for the other
direction of the joystick. ☞Steps 3–6
When you have finished making settings for both directions, press the
9
[ENTER] key.
The settings will be updated, and you will return to Play mode.
If you want to keep the new settings, you must save them in Scene
mode. If you turn off the power or select a different scene without
saving, your new settings will be lost. (☞p.54 "Scene mode–[16]
WRITE")
[6] JOYSTICK-Y (Joystick–Y assignment)
In Joystick–Y assignment you can specify the MIDI message and channel
that will be transmitted for forward/backward (±Y) joystick movements.
You can assign separate MIDI messages to the forward and backward (±Y)
directions.
You can assign pitch bend, master balance, aftertouch, velocity, or control
changes (CC#).
1 Hold down the [SETTING] key and press pad [6].
The [SETTING] key and pad [6] will light, and you will be in the
Joystick–Y assignment page. The main display indicates "Assignment
Select" (select the type of assignment).
The assignable content and the assignment procedure are the same as
for the joystick left/right (±X) direction. For details on how to make
settings, refer to "Joystick-X assignment" (☞p.31).

[7] STICK SW (Joystick switch assignment)

In Joystick switch assignment you can assign a MIDI message to the joystick
switch and specify how the switch will operate.
You can assign damper, sostenuto, soft pedal, portamento, or control change
(CC#) messages to the joystick switch.
1 Hold down the [SETTING] key and press pad [7].
The [SETTING] key and pad [7] will light, and you will be in the
Joystick switch assignment page. The main display will indicate
"Message Select" (select the MIDI message).
The assignable content and the assignment procedure are the same as
for the pedal. For details, refer to "Pedal assignment" (☞p.29).
Operation–Setting mode
35