Pad Velocity (Pad Velocity Setting); Lcd Backlig (Lcd Backlight Setting) - Korg microKONTROL Owner's Manual

[10] PAD VELOCITY (PAD Velocity setting)

The PAD Velocity setting page lets you specify the type of velocity that will
be used when transmitting note messages from the pads.
You can choose to control the output velocity according to the strength with
which you strike the pads, or to always send a fixed value.
1 Hold down the [SETTING] key and press pad [10].
Pad [10] and the [SETTING] key will light, and you will be in the PAD
Velocity setting page. The main display will indicate "Velocity Type"
(select the velocity type).
2 Use the [VALUE] dial to select the velocity type.
VelSens (Velocity Sens)
The transmitted velocity value will vary in steps according to the
strength with which you strike the pads.
If you select VelSens, the setting will be saved when you press the
[ENTER] key (blinking).
Constant
The transmitted velocity value will not be affected by the strength with
which you strike the pads.
If you select Constant for "Velocity Type," press the OCTAVE SHIFT/
3
CURSOR [®] key to proceed to "Constant" (specify the velocity value),
and use the [VALUE] dial to specify the velocity value. The range is 1–
127.
(Red)
4 Press the [ENTER] key.
The settings will be saved, and you will return to Play mode.
(Green)

[11] LCD BACKLIG (LCD Backlight setting)

The LCD Backlight setting specifies the backlight color of the main display
and sub-displays. You can choose between red, green, orange, and off.
For the sub-displays you can specify the backlight color separately for the
encoder and slider indications. The display backlight color will change
according to the controller you operate.
1 Hold down the [SETTING] key and press pad [11].
The [SETTING] key and pad [11] will light, and you will be in the LCD
Backlight setting page. The main display will indicate "Display Select"
(select the display whose settings you want to make).
Use the [VALUE] dial to select the display for which you want to make
2
settings.
Encd (Encoder)
Specify the backlight color for when the sub-display is showing an
encoder.
Sldr (Slider)
Specify the backlight color for when the sub-display is showing a
slider.
Main
Specify the backlight color of the main display.
3 Press the OCTAVE SHIFT/CURSOR [®] key to proceed to "Backlit
Select" (select the backlight color).
(Red)
Operation–Setting mode
(Green)
39