Glob.ch (Global Midi Channel Setting); Polarity (Polarity Setting); System (System Setting) - Korg microKONTROL Owner's Manual

[14] GLOB.CH (Global MIDI Channel setting)

The Global MIDI Channel setting specifies the global MIDI channel; the
channel on which note data is transmitted when you play the keyboard.
1 Hold down the [SETTING] key and press pad [14].
The [SETTING] key and pad [14] will light, and you will be in the
Global MIDI Channel setting page. The main display will indicate
"Global MIDI Channel" (set the global MIDI channel).
2 Use the [VALUE] dial or the pads to select the global MIDI channel.
The range is 1–16 (ch). (☞p.4 "About the trigger pad functions–Input
numerical values")
3 Press the [ENTER] key.
The setting will be saved, and you will return to Play mode.

[15] POLARITY (Polarity setting)

The Polarity setting specifies the polarity of the damper pedal or pedal
switch connected to the rear panel PEDAL jack.
1 Hold down the [SETTING] key and press pad [15].
The [SETTING] key and pad [15] will light, and you will be in the
Polarity setting page. The main display will indicate "Pedal Polarity"
(pedal polarity setting).
2 Use the [VALUE] dial to specify the polarity of the pedal you have
connected.
+: Select this setting if the connected pedal has a + (↑) polarity.
–: Select this setting if the connected pedal has a – (↓) polarity. Use the
"–" setting if you have connected a Korg damper pedal (the optional
DS-1H) or a Korg pedal switch (the optional PS-1). If no pedal is
connected to the PEDAL jack, select the "–" setting.
3 Press the [ENTER] key.
The setting will be saved, and you will return to Play mode.

[16] SYSTEM (System setting)

This specifies the initial values of the encoders when you reselect a scene.
1 Hold down the [SETTING] key and press pad [16].
The [SETTING] key and pad [16] will light, and you will be in the
System setting page. The main display will indicate "Value" (specify
the initial value).
2 Use the [VALUE] dial to specify the initial value.
You can select either 000, 064, 127, or Last as the initial value.
If you select Last, the last-set encoder value will be the initial value.
3 Press the [ENTER] key.
The saving will be saved, and you will return to Play mode.
Operation–Setting mode
41