Preparation Before Operation; Inserting The Needle; Threading The Needle-Thread - JUKI AMB-289/IP-420 Instruction Manual

3. PREPARATION BEFORE OPERATION

(1) Inserting the needle

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
A
3 3
2 2

(2) Threading the needle-thread

WARNING :
To protect against possible personal injury due to abrupt start of the machine, be sure to start the
following work after turning the power off and ascertaining that the motor is at rest.
Pass the needle thread in the order 1 to !3 as shown in the figures.
1 1
2
3
9
!0
!1
8
!2
!3
Ⅰ–14
Hold needle with its recessed part facing toward
side "A" as observed from the front of the sewing
machine, insert the needle into the needle hole
of needle bar until it will go no further, and tighten
setscrew 1 with a flat-blade screwdriver.
Use a SM332EXTLG-NY(#11 to #18).
When attaching the needle, turn OFF
the power to the motor.
Attach stop plug 2 supplied as
accessories (insert magnet 3
supplied as accessories into the top
end) to the needle. It is recommended
to confirm that the needle is vertical.
1
4
5
7
6