Observing The Working Measurement Information - JUKI AMS-210E/IP-410 Instruction Manual

(5) observing the working measurement information

A
A
C
1 Display the information screen.
When nformaton key
pressed n the data nput screen, the nformaton screen s
dsplayed.
2 Display the working measurement screen.
Press workng measurement screen dsplay button
n the nformaton screen. The workng measurement screen s
dsplayed.
B
Informaton on the followng 5 tems are dsplayed n the work-
ng measurement screen.
A : The nformaton s automatcally dsplayed from the tme
of start of measurng the workng rato.
B
B : The nformaton s automatcally dsplayed from the tme
of start of measurng the machne speed.
C : The nformaton s automatcally dsplayed from the tme
D
of start of measurng the ptch tme.
D : The nformaton s automatcally dsplayed from the tme
E
of start of measurng the machne tme.
E : Number of tmes of thread trmmng s Input the number
of tmes referrng to tem 3) on the next page.
3 Input the number of times of thread trimming.
Next, nput the number of tmes of thread trmmng per pro-
cess. When NUMBER OF TIMES OF THREAD TRIMMING
button E s pressed, the number of tmes of thread
trmmng nput screen s dsplayed.
Input the value you desre wth ten keys or UP/DOWN buttons.
After the nput, press ENTER button
C
* When the input value is 0, count of the number of times
of thread trimming is not performed. use this function by
connecting the external switch.
– 76 –
A of the swtch seat secton s
C .
B