Copying Pattern Button - JUKI AMS-210E/IP-410 Instruction Manual

2-19. Copying pattern button

The sewing data of the pattern button No. which has already been registered can be copied to the pat-
tern button No. which is not registered. Overwriting copy of the pattern button is prohibited. When you
desire to overwrite, perform it after deleting the pattern button once.
/ Refer to "@-2-17. Performing pattern button No. selection" p.57.
A
4 Determine the change of item data
For example, input X scale rate. Press
the item data input screen. Input the value you desire with the
K
ten keys or + or – key K . When ENTER button
pressed, the data is determined.
L
5 Close the pattern button data change screen.
M
When the change is over, press CLOSE button
The pattern button data change screen is closed and the
screen returns to the data input screen.
* It can be performed to change the other item data by the same
operation.
In case thread tension is changed in the read state,
the set value when the power is turned OFF without
pressing READY key
sewing is not stored in memory.
1 Display the data input screen.
Only in case of the data input screen (blue) at the time of pat-
tern button selection, it is possible to copy. In case of the sew-
ing screen (green), press READY switch
data input screen (blue).
2 Call the pattern copy screen.
When PATTERN BUTTON COPY button
the pattern button copy (copy source selection) screen is dis-
played.
– 60 –
B to display
L is
M .
or without performing
to display the
A is pressed,