Intermediate Presser Height - JUKI AMS-210E/IP-410 Instruction Manual

4-7. Intermediate presser height

When raising the intermediate presser height, turn the pulley by hand to lower the needle
bar, and confirm that the needle bar does not interfere with the intermediate presser. (When
using DP X 5 needle, use the sewing machine with the height of 3.5 mm or less.)
[IP-410]
[cP-20]
1. setting range of the intermediate presser is up to the standard of 3.5 mm.
However, when using DP X 17 needle for H type or the like, the setting range can be
changed up to max. 7 mm with memory switch u112.
2. When increasing the height of intermediate presser or making the needle size thicker,
confirm the clearance between the wiper and the components. Wiper cannot be used
unless the clearance is secured. In this case, turn oFF the wiper switch, or change
the set value of memory switch u105.
A
Press INTERMEDIATE PRESSER SETTING button A and adjust
wth TEN keys B so that the clearance between the bottom end of
ntermedate presser and the cloth s 0.5 mm (thckness of thread
used).
B
h
1) Select the ntermedate presser wth
2) Press key to lower the ntermedate
presser.
3) Adjust wth
clearance between the bottom end of
ntermedate presser and the cloth s 0.5 mm
(thckness of thread used) when the needle s n
ts lowest poston.
– 21 –
0.5 mm
or key so that the
key.