HP B2355-92068 Administration Manual page 293

fsck_vxfs(1M)
RETURN VALUES
Structural errors discovered during a full check are displayed on standard output. Responses required dur-
ing a full check are read from standard input.
The following return codes are used for the
system:
The file system is unmounted and clean.
0
The file system is unmounted and needs checking.
32
The file system is mounted.
33
34 The stat of the device failed.
Other
The state could not be determined because of an error.
The following return codes are used for the
The root file system is mounted read-only and is clean, or the root file system is mounted
0
read/write and therefore is clean.
32 The root file system is mounted read-only and needs checking.
The stat of the device failed.
34
Other
The state could not be determined because of an error.
In most cases, prints the following messages:
fsck
log replay in progress
replay complete - marking super-block as CLEAN
If the file system is already clean,
file system is clean - log replay is not required
If fsck prints any other messages, a full structural check is needed. If the
performs (if necessary) a full check after running the intent log replay. If the
must be invoked with the
If or is specified,
-o p -P
/dev/rdsk/c0t0d0
/dev/rdsk/c0t0d0:log replay in progress
/dev/rdsk/c0t0d0:replay complete - marking super-block as CLEAN
DIAGNOSTICS
All error messages that relate to the contents of a file system produced during a log replay are displayed on
standard output. All I/O failures and exit messages are displayed on standard error.
WARNINGS
allows a full check of a mounted file system.
-o mounted
of the primary cluster node recovery process after the primary fails. Never enter this option from the com-
mand line as it can destroy a file system if not used correctly.
The -s (safe performance mode) option will be obsoleted in future releases.
SEE ALSO
fsck(1M), fsck_hfs(1M), mkfs(1M), mkfs_vxfs(1M), ncheck_vxfs(1M), sync(2), fs_vxfs(4).
HP-UX 11i Version 2: December 2007 Update
option for all devices other than the one used by the root file
-m
-m option for the device used by the root file system:
prints the following message instead:
fsck
-o full option to perform a full structural check.
prints the following messages for a device, for example
fsck
:
− 3 −
fsck_vxfs(1M)
-y option is specified,
option is not used,
-y
is only used internally as part
-o mounted
Hewlett-Packard Company
f
fsck
fsck
293