Table of Contents
Advertisement
drd-clone(1M)
-x mirror_disk=
-x overwrite=false
d
-x preview=false
-x verbosity=3
The Source
The source for the
file system (
Choosing a Target Disk
The target disk must be specified as a block device file. An appropriate target disk should be writeable by
the system, not currently in use by other applications, and large enough to hold a copy of each logical
volume in the root group.
The physical disk need not be as large as the disk allocated for the root group as long as there is sufficient
space for a copy of each volume in the root group. However, the disk will need to be bigger than the used
space in each volume, since each volume will be created with the number of physical extents currently allo-
cated to the corresponding root volume.
202
Hewlett-Packard Company
4
Adds verbose INFO messages.
Adds very-verbose INFO messages.
5
mirrordisk
Usage: Basic
The block device special file of the mirror disk of the target. The device special file mirror-
disk, should refer to an entire disk, not to a partition. This option requires that LVM mir-
roring be installed. The block device file specified will be used to mirror each logical volume
in the target of the clone operation.
Usage: Basic
Controls whether or not a disk containing boot, LVM, or VxVM records can be overwritten.
Note that DRD will not overwrite a disk associated with an active LVM volume group or
VxVM disk group, regardless of the setting of the
created clone is mounted, use the
ing to create a new clone on the disk.
true
Allow a disk to be overwritten, even if it contains boot, LVM, or VxVM records.
false
Prevent a disk that contains boot, LVM, or VxVM records from being overwrit-
ten.
Usage: Basic
If
true
, run this command in preview mode only (that is, complete the analysis phase and
exit; do not commit changes to disk). Setting this option to
specifying
-p
on the command line.
Usage: Basic
Specifies the level of standard error verboseness. Legal values are:
Display only ERROR messages and the starting/ending BANNER messages.
0
Adds WARNING messages.
1
2
Adds NOTE messages.
3
Adds INFO messages (informational messages preceded by the
Adds verbose INFO messages.
4
Adds very-verbose INFO messages.
5
See also the
and
-v
-q
verbosity by 1 (for example, from 3 to 4) and the
The
-v
and
-q
options can be given more than once. Multiples can be merged, as in
For example, if both
-x verbosity=5
the effective verbosity is 2. The minimum combined verbosity level is 0.
For example, if both
-x verbosity=1
effective verbosity is 3. The maximum combined verbosity level is 5.
drd clone
command — the group that is copied — is the group containing the root
).
/
drd umount
command to unmount it before attempt-
options in the Options section above. The
-q
and
-qqq
and
-vv
− 2 −
HP-UX 11i Version 2: December 2007 Update
drd-clone(1M)
option. If a previously
overwrite
has the same effect as
true
*
character).
option increases the
-v
option decreases the verbosity by 1.
are included on the command line,
are included on the command line, the
-qq
.
Advertisement
Table of Contents
