Fujitsu Eternus DX80 S2 User Manual page 114

Appendix A Event Notification Message List
A.2 Message List
Event type
M E2070001
M E2070002
M E2070004
M E207000B
M E207000C
M E207000D
M E207000E
M E207000F
M E2070010
M E2070011
M E2070015
M E2070016
M E2070017
M E2070018
ETERNUS DX80 S2/DX90 S2 Disk storage system User's Guide -Operation-
SNMP Trap
Trap
Trap
code
Maintenance
No.
Info
7 E2070001
7 E2070002
7 E2070004
7 E207000B
7 E207000C
7 E207000D
7 E207000E
7 E207000F
7 E2070010
7 E2070011
7 E2070015
7 E2070016
7 E2070017
7 E2070018
Copyright 2011 FUJITSU LIMITED
Upper: Message
Lower: Description
NOT READY(01:Configuration Error)
The device is in Not Ready status.
Shipment settings (model setting) and configurations are
not applied.
NOT READY(02:CM F/W Version Error)
The device is in Not Ready status.
Firmware version for the CM is not correct.
NOT READY(04:Restore Fail)
The device is in Not Ready status.
Backup is successfully complete, but cannot perform the
restoration.
NOT READY(11:Power Off/Fail Incomplete)
The device is in Not Ready status.
Failed to power off. Or the device power turns off
immediately after the device powers on.
NOT READY(12:Backup Fail)
The device is in Not Ready status.
Backup failed.
NOT READY(13:Multi CM Down)
The device is in Not Ready status.
Adjoining CMs with LUs are degraded.
NOT READY(14:Machine Down Recovery End)
The device is in Not Ready status.
Machine down recovery is performed.
NOT READY(15:Machine Down Recovery Failed)
The device is in Not Ready status.
Failed to perform machine down recovery.
NOT READY(16:DE Build Error)
The device is in Not Ready status.
Failed to configure DE because of QSFP cable errors or
FC cable errors.
NOT READY(17:CM Memory Shortage)
The device is in Not Ready status.
Memory capacities are smaller than the minimum value in
multiple CMs.
NOT READY(21:Auto CFD)
The device is in Not Ready status.
Automatic CFD is performed.
NOT READY(22:No Version)
The device is in Not Ready status.
The version table is invalid.
NOT READY(23:AC Input Shortage)
The device is in Not Ready status.
AC power input is insufficient.
NOT READY(24:Configuration Data restored from
System Disk)
The device is in Not Ready status.
Configuration information is restored using the backup
area due to the replacement of a CM (including BUD).
114
Remarks
These messages
are notified when
"Not Ready" is
enabled for Error
Severity Level in
the event
notification
setting. They are
not notified
during
maintenance
operations.
P3AM-4842-01ENZ0