Setting Up The Boot Server - Polycom SIP 3.0.2 Administrator's Manual

Administrator's Guide SoundPoint IP / SoundStation IP
Name
Server Address
Server Type
Facility
Render Level
Prepend MAC
Address

Setting Up the Boot Server

3 - 12
Syslog Menu
Syslog is a standard for forwarding log messages in an IP network. The term
"syslog" is often used for both the actual syslog protocol, as well as the
application or library sending syslog messages.
The syslog protocol is a very simplistic protocol: the syslog sender sends a
small textual message (less than 1024 bytes) to the syslog receiver. The receiver
is commonly called "syslogd", "syslog daemon" or "syslog server". Syslog
messages can be sent through UDP, TCP, or TLS. The data is sent in cleartext.
Syslog is supported by a wide variety of devices and receivers. Because of this,
syslog can be used to integrate log data from many different types of systems
into a central repository.
The syslog protocol is defined in RFC 3164. For more information on syslog,
go to http://www.ietf.org/rfc/rfc3164.txt?number=3164
The following syslog configuration parameters can be modified on the Syslog
menu:
Possible Values
dotted-decimal IP address
OR
domain name string
None=0,
UDP=1,
TCP=2,
TLS=3
0 to 23
0 to 6
Enabled, Disabled
The boot server can be on the local LAN or anywhere on the Internet.
Description
The syslog server IP address or host name.
The default value is NULL.
The protocol that the phone will use to write to the syslog
server.
If set to "None", transmission is turned off, but the server
address is preserved.
A description of what generated the log message. For
more information, refer to section 4.1.1 of RFC 3164.
The default value is 16, which maps to "local 0".
Specifies the lowest class of event that will be rendered to
syslog. It is based on log.render.level and can be a
lower value.
Refer to Basic Logging <level/><change/> and <render/>
on page A-77.
Note: Use left and right arrow keys to change values.
If enabled, the phone's MAC address is prepended to the
log message sent to the syslog server.
.