Call Handling Configuration <Call - Polycom SIP 3.0.2 Administrator's Manual

Administrator's Guide SoundPoint IP / SoundStation IP
Attribute
httpd.cfg.enabled
httpd.cfg.port
Call Handling Configuration <call/>
Attribute
call.rejectBusyOnDnd
call.enableOnNotRegistered
call.offeringTimeOut
call.ringBackTimeOut
A - 58
This attribute also includes:
Configuration <cfg/>
Configuration <cfg/>
This configuration attribute is defined as follows:
Permitted
Values Default
0, 1 1
1-65535 80
This configuration attribute is defined as follows:
Permitted
Values
0, 1
0, 1
positive
integer
positive
integer
Interpretation
If set to 1, the HTTP server configuration interface
will be enabled.
Port is 80 for HTTP servers. Care should be taken
when choosing an alternate port.
Default Interpretation
1 If set to 1, reject all incoming calls with the
reason "busy" if do-not-disturb is enabled.
Note: This attribute is ignored when the line is
configured as shared. The reason being that
even though one party has turned on DND, the
other person/people sharing that line do not
necessarily want all calls to that number diverted
away.
Note: If server-based DND is enabled, this
parameter is disabled.
1 If set to 1, calls will be allowed when the phone is
not successfully registered, otherwise, calls will
not be permitted without a valid registration.
60 Time in seconds to allow an incoming call to ring
before dropping the call, 0=infinite.
Note: The call diversion, no answer feature will
take precedence over this feature if enabled. For
more information, refer to
<noanswer/>
60 Time in seconds to allow an outgoing call to
remain in the ringback state before dropping the
call, 0=infinite.
No Answer
on page A-97.