Polycom SIP 3.0.2 Administrator's Manual page 205

Attribute
mb.idleDisplay.refresh
Attribute
mb.main.home
mb.main.statusbar
mb.main.idleTimeout
Permitted Values
0 or an integer > 5
Main Browser <main/>
This setting controls the home page used by the Microbrowser when that
function is selected.
Permitted Values
Any fully formed valid
HTTP URL. Length
up to 255 characters.
0, 1
0 - 600, seconds
Default Interpretation
0 The period in seconds between refreshes of the
idle display Microbrowser's content. If set to 0,
the idle display Microbrowser is not refreshed.
The minimum refresh period is 5 seconds
(values from 1 to 4 are ignored, and 5 is used).
Note: If an HTTP Refresh header is detected, it
will be respected, even if this parameter is set to
0. The refresh parameter will be respected only
in the event that a refresh fails. Once a refresh is
successful, the value in the HTTP refresh
header, if available, will be used.
Default Interpretation
Null URL used for Microbrowser home page. If blank,
the browser will notify the user that a blank
home-page was used.
For example:
http://www.example.com/xhtml/frontpage.cgi?pa
ge=home.
Null Flag to determine whether or not to turn off
display of status messages.
If set to 1, the display of the status bar is
enabled.
If set to 0, or Null, the display of the status bar is
disabled.
Null Timeout for the interactive browser. If the
interactive browser remains idle for a defined
period of time, the phone should return to the
idle browser.
If set to 0, there is no timeout.
If set to Null, the value from up.idleTimeout is
used. Refer to
A-23. If mb.main.idleTimeout and
up.idleTimeout are Null, the timeout is 20
seconds.
If set to value greater than 0 and less than 600,
the timeout is for that number of
Configuration Files
User Preferences <up/>
seconds.
on page
A - 87