Using The Remote Control - Polycom PowerCam Presenter User Manual

User's Guide for the Polycom PowerCam Presenter

Using the Remote Control

Select an item from the
user settings screens
Adjust the Presenter View
(when automatic camera
tracking is enabled);
manually pan and tilt the
camera (when automatic
camera tracking is disabled);
navigate through menus
(when viewing the user
settings screens)
Zoom the Presenter View
in or out (when automatic
camera tracking is enabled);
manually zoom the camera
in or out (when automatic
camera tracking is disabled)
Zoom in more closely on
the presenter (and enable
automatic camera tracking,
if it's currently disabled)
Move the camera to the
left of the presenter (and
enable automatic camera
tracking, if it's currently
disabled)
2 - 2
• You can connect a display to connector
or composite; however, be sure to use whichever matches the display's
video input.
• Polycom recommends that you do not use audio with the display
connected to connector
experience video delay and lip synchronization issues.
The IR remote control enables you to control the PowerCam Presenter. You
can use it to enable and disable automatic camera tracking, adjust the camera,
and navigate the screens.
on the controller using S-video
on the controller. If you do so, you will
Menu
Select
Zoom In Preset 1
Auto Zoom
Zoom Out Preset 2
Presenter View
Tight Wide Off
Left Right
Access the user settings
screens or return to showing
video
Enable or disable automatic
zooming for the Presenter
View
Store or recall a camera
position (and disable
automatic camera tracking,
if it's currently enabled)
Disable automatic camera
tracking
Zoom out further away from
the presenter (and enable
automatic camera tracking,
if it's currently disabled)
Move the camera to the
right of the presenter (and
enable automatic camera
tracking, if it's currently
disabled)