Configuring User Settings; Configuring Camera Settings; Configuring Input Signal, Camera Direction, And Backlight; Compensation - Polycom PowerCam Presenter User Manual

Configuring User Settings

Configuring Camera Settings

Keep in mind that the
settings described here are merely guidelines, and that you can set and change
the settings to best suit your needs. For more information, refer to
Using Presenter Views
When the message
Remote control batteries are low
need to replace the batteries.
The Menu button on the remote control gives you access to the user
settings. These settings enable you to configure and calibrate the camera, set
LAN properties, and specify video output settings.
The Camera Settings screen lets you specify the settings for the input signal,
backlight compensation, camera direction, and the camera tracking area.
Configuring Input Signal, Camera Direction, and Backlight Compensation
You may need to set or change these camera settings depending on your
preferences and on the environment in which you use your PowerCam
Presenter.
To configure the settings for input signal, camera direction, and backlight

compensation:

1. Press Menu on the remote control.
2. Select Camera Settings from the PowerCam Presenter screen.
3. Configure these settings:
Setting
Input Signal
Tight, Wide,
Tight Wide
on page 2-12.
Description
Specifies your camera's input signal:
• Select S-Video if you connect your camera to the
PowerCam Presenter controller using the
S-video connector on the camera.
• Select Composite if you connect your camera to
the PowerCam Presenter controller using the
composite connector on the camera.
Using the Polycom PowerCam Presenter
Left, and Right button
Left Right
Setting and
appears on the screen, you
2 - 3