Record Control Setup - Euphonix System 5 Setup Manual

Post and film

Hide thumbs Also See for System 5:

Table of Contents

Euphonix System 5 Post and Film Setup Guide

Record Control Setup

Version 2.5 of eMix added record and track-arming functionality to the System 5 console.

Version 3.0x (or higher) of the TT007 software is required.

One record machine with up to 48 tracks is supported; additional record machines can

be supported using third-party hardware. Contact Euphonix customer support for more

information.

Perform the following steps to enable record- and track-arming:

From the Main Panel on the CM401, select Machines.

Select Setup and set the options on this panel to reflect your preferred method

of operation.

NOTE: Only the master console should be set to "Disarm on Stop" if this option is de-

sired. Setting both consoles to do this will cause problems with tally informa-

tion.

3. On the TT007, display the Utility menu.

Set REC Safe to Off.

The TT007 normally sends record commands to the Master machine. To

record- or track-arm a Slave machine, set Re-Direct to the port of the machine

you wish to control.

Enter Port Mode by pressing the port's button twice.

7. Set Record to Edit and Track Arm to On.

Table of Contents

Do you have a question about the System 5 and is the answer not in the manual?