Hand Held Products 9500 Supported Equipment Manual page 42

Terminal Setup
Setting the Segment
Checking the
IP Address can be any valid address on the segment, as it is used
s egment. The setting of the Net Mask can be used to restrict the range. This feature is
u seful for segregating terminal groups by location.
Setting Force Reload
Clicking on the
automatically updated. The following warning message appears.
Click on the
Setting the Default Terminal Group
New terminals that have not yet been assigned to any group are initially assigned to the
default group in effect when they are cold booted.
Any group can be made the default group by clicking on the group, and then clicking on
the right mouse button. Then click on the
Reassigning Terminals
After a terminal has been configured and assigned to the default group, it can be
reassigned to a new group by clicking on the terminal icon as shown below.
Then, holding the mouse button down, drag the terminal icon to the desired group.
2-32
button restricts a terminal group to a range of IP addresses. The
Segment
button forces all terminals within a group to be
F orce Reload
button to force the reload.
Yes
only to identify the
option.
Make Default
Supported Equipment Manual
•
January, 2006