Configuring The Terminal For Download; Power, Radio, And Signal Icons - Hand Held Products 9500 Supported Equipment Manual

Supported equipment manual
Hide thumbs Also See for 9500:
Table of Contents

Advertisement

Terminal Setup

Configuring the Terminal for Download

The 7400 and 9500 terminals are configured for download using ActiveSync, as
described in the Sending Configuration Files to the 7400/9500 Terminal section.
The following is the cold boot sequence that each requires.
Cold Booting the Terminal
Following Power
Troubleshooting
Error
Indication
No AirLoad
Manager
Found
Manager not
Active
After taking the corrective action, the terminal must be cold booted. A successful
wireless connectio
Twin Client
© 1991-2006, Connect, Inc.
Keypress To Continue
The date of 2006 is updated on the terminal at the time of a new release.
Not
e:
The term
Po
wer, Radio, and Signal Icons
The following icons are found at the lower left corner of the Windows-based*
term
inal screen.
T
he
power status
remaining battery power level (low =
The
radio association
(darker
The
link reception
(low =
To utilize these icons, select
Click in the
Then select
* for Pocket PC 2003 and later, and Windows CE 4.2 and later
2-12
press the
OFF,
Possible Cause
AirLoad Manager not
active, or not installed on
the LAN segment
Previously identified
AirLoad Manager is no
longer found.
n and download is shown by the Twin Client main menu below.
inal is now ready to establish a Telnet session with the host sy
icons indicate a wall outlet power source (
icons indicate if terminal is connected to the radio
icon
= connected, lighter icon
icons indicate signal strength
, moderate =
, high =
Settings
Use GUI menus and screens
, and
Terminal
Send Configuration Files to Terminal.
and
keys for several seconds, then release.
ESC
CTRL
Corrective Action
Ensure that PC with Twin Client Manager is
on same segment and that PC is operating. If
PC is not on same segment, enter address of
PC in response to the terminal prompt.
Same as above.
, moderate =
= not connected).
).
, and then
Terminal Operation.
check box, and click on
Supported Equipment Manual
stem.
) or the
, high =
).
.
OK
January, 2006

Advertisement

Table of Contents
loading

This manual is also suitable for:

7400

Table of Contents