Hand Held Products 9500 Supported Equipment Manual page 115

Message
Font Loading Erro r;
Printer Not Ready\nPress R to
Retry\nC to Cancel Print;
Mobile Unit in\nDemonstration
Mode\nfor Tw inClient;
Connected to Host;
Telnet Mode not\nsupported on\nthis
Mobil e Unit;
Telnet Setup files\nnot found.
Reload\nfiles then switch;
Switched Client to\nTelnet Direct Mode; Mobile Unit running in Telnet mode
Switched Client to\nServer Based
Mode;
Port 23 is only\nallowed in Telnet
Mode;
Not Enough Memory\nTo Run;
Press any key;
•
Supported Equipment Manual
Reason
Could no t load the font.
Can not print.
Running in demo mode.
Successful connection to the target Advisory message.
Host.
This Mobile Unit must be used with
a Connec t Server.
Customer specific configuration
files are missing.
direct to the target Host.
Mobile Unit running through a
Connect server in Server mode
usually a t port 1800.
Can not set the port to 23 in Server
mode. Port 23 is the standard
Telnet po rt.
Mobile Unit does not have the
capacity to run the program do to
memory restrictions.
Press a key to continue.
January, 2006
Solution
Ensure that the font is available to
load.
Check cable, battery, communication
settings and paper in the printer.
Purchase a license from Connect.
Order a Connect Server.
Load the configuration files into the
Mobile Unit from Twin Client Manager.
Advisory message.
Advisory message.
Advisory message.
Expand the Mobile Unit memory.
Advisory message.
Error Message Resolution Guide
Reference Tech Note
---
---
---
---
---
---
---
---
---
---
---
4-7