If you are installing a standard (non-CineWide) X-200i, skip this step and proceed with
Mounting the X-200i (page 28).
If you are installing an X-200i/CineWide with a "McKinley" (cylindrical)
anamorphic lens, proceed with Installing the Fixed CineWide Base
Plate (Cylindrical Anamorphic Lens) (page 27).
If you are installing an X-200i/CineWide with a "Whitney" (prismatic)
anamorphic lens, proceed with Installing the Fixed CineWide Base
Plate (Prismatic Anamorphic Lens) (page 26).
If you are installing an X-200i/CineWide with AutoScope, proceed as follows to install the
AutoScope lens motor.
1. Do not install the CineWide lens yet, only the fixed CineWide
Note
2. Some components shipped with your projector may differ slightly
Remove Projector Feet: Place the
projector upside down on a blanket or
other soft surface. Loosen and remove
the two front feet on the projector.
Runco X-200i Series Installation/Operation Manual
base plate or AutoScope lens motor. You will install the
CineWide lens after you install the projector and adjust the
primary lens.
from what is shown in these instructions.
23
Installation
3.4
Installing the Optional
CineWide Lens Mount