Quick Setup - Runco Video Xtreme VX-44d Installation & Operation Manual

Installation
3.2

Quick Setup

Table 3-1 gives a quick overview of the VX-44d/-55d installation process. The sections
following this one provide detailed instructions.
Installation must be performed by a qualified custom video
Note
installation specialist.
Table 3-1. Installation Overview
Step
1 Choose a location for the projector
2 Install primary projection lens
3 Install CineWide lens mounting assembly (stationary base
plate or AutoScope lens motor – optional)
4 Mount the projector
5 Connect the DHD Controller to the projector
6 Connect signal sources to the DHD Controller
7 Connect external controller to RS-232 port (optional)
8 Connect AutoScope lens motor and/or other equipment to
12-volt trigger outputs (optional)
9 Apply power to the projector
10 Primary lens adjustments: projected image size (zoom),
position (shift) and focus
11 For rear-screen and/or ceiling-mount installations, select
the proper picture orientation
12 Install CineWide anamorphic lens (optional)
13 CineWide lens adjustments: position, pitch (angle),
geometry and focus
14 Adjust lamp output and optical aperture, as needed
15 DHD Controller input calibration: adjust the following for
each DHD Controller input and display mode (resolu-
tion/frame rate); save settings when finished:
• Aspect ratio
• Brightness
• Contrast
• Color temperature and white balance
Procedure
• Color level
• Tint
• Input position
18 Runco VX-44d/-55d Installation/Operation Manual
For Details, Refer to
page...
19
25
26
28
29
30
36
37
39, 40
21, 41
41
42
43
49
55 through 69